Our Certified Services

Attached housing concentrates moisture risk in shared systems. A failed section of shared roofing, a leaking plumbing stack inside a party wall, or a rooftop HVAC condensate overflow can put moisture into a neighboring unit's walls months before anything is visible. Fixed-schedule HOA irrigation also keeps soil damp against foundations all year. The deciding question is whether the moisture started inside the unit or in a common element, because that usually determines who pays. An independent inspection traces the moisture pathway with thermal imaging and moisture meters and documents it with no financial interest in the outcome.

They often are. Homes from this era are now 50 to 65 years old, with original galvanized or early copper plumbing near end of life, original bath fans that may still vent into the attic, and roofing and HVAC systems that have been replaced at least once. Many are slab-on-grade, which hides moisture problems: a slow supply-line leak can wick into drywall and framing with no visible sign at floor level, and Orange County's mild climate lets that moisture support growth year-round. Thermal imaging and moisture meters find in-wall and under-slab moisture that a visual check misses.

Homes built into the foothills sit on graded pads with retaining walls, weep holes, and subdrains that keep slope moisture away from foundations. Over time, weep holes plug with mineral deposits and roots, and subdrains clog or crush, so slope runoff that used to be managed starts to concentrate at downhill foundations. Irrigation used for slope plantings can also push water into fill that was compacted to shed it. The result often shows up as a damp lower level or garage long after the last rain. An inspection focuses on the downhill and below-grade walls, foundation drainage, and any lower-level living space.

Yes, though through different mechanisms. Newer construction is built tight for energy efficiency, which traps interior humidity when ventilation underperforms, and moisture trapped behind stucco and exterior cladding has little path to dry out. Water intrusion through stucco, window flashing, and balcony or deck waterproofing is among the most common defects in newer California communities, and it often appears within the first several years. Because the damage sits behind hard cladding, it is typically found with moisture meters and thermal imaging rather than a visual check.

Yes, particularly for attached units, foothill lots, and homes from the 1960s and 1970s. The inspection covers thermal imaging for behind-wall moisture, slab and foundation readings, attic ventilation, and air or surface sampling where growth is suspected. For condos and townhomes it also documents whether a moisture condition comes from a shared building system, which affects who pays for repairs. Independent documentation before closing protects you from inheriting a slow, long-running problem.

Our Lake Forest team covers the whole city of Lake Forest, including El Toro, Foothill Ranch, Portola Hills, Baker Ranch, and Serrano Highlands, with same-day and next-day appointments and 24/7 emergency response. Mission Viejo and Irvine each have their own 24H Mold Inspection page with a local team. If your property is in either city, start with that page. If you are not sure which page fits your address, call the number on this page and we will point you to the right team.

The inspection is the diagnosis. We map moisture with thermal imaging and meters, identify the source, and send samples to an accredited lab, then deliver a written report with the extent of growth, the cause, and a defined scope. The cleanup is done by a separate remediation contractor, because we perform inspection and testing only. That separation matters in HOA communities, where the party paying for the repair needs documentation with no financial interest in the size of the job. Once the work is done, we can return for independent post-remediation verification.